我的账户
莆田百事通

自媒体资讯干货

亲爱的游客,欢迎!

已有账号,请

立即登录

如尚未注册?

加入我们
  • 客服电话
    点击联系客服

    在线时间:8:00-16:00

    客服电话

    400-000-0000

    电子邮件

    xjubao@163.com
  • APP下载

    莆田百事通APP

    随时随地掌握行业动态

  • 官方微信

    扫描二维码

    关注莆田百事通公众号

莆田百事通 网站首页 资讯列表 资讯内容

广东省明义机械贸易有限公司链条的使用、维护和保养

2021-01-23 发布于 莆田百事通
广东省明义机械贸易有限公司链条的使用、维护和保养
1、链条在传动中应保持良好的工作环境,应有保护装置,尽量避免尘粒、泥沙等障碍物进入,并及时给予清洗,以免链条过失损坏。
2、及时调整张紧装置,保持链条运转稳定。
3、链条在使用过程中,正常的磨损会使链条逐渐伸长,结果链条下垂度会逐渐变大,链条产生剧烈跳动,链条磨损加大,甚至出现跳齿、脱齿的现象,因此应及时调整其松紧度,并观察前后链轮与链条及相关部件是否在同一直线上,发现问题应立刻校正,免除后患,确保万无一失。
4、链条应保持清洁,并定期对其注油保养,采用30号、40号机油,可用油刷(无条件时毛刷也可)将润滑油均匀地分布在链条铰链 间隙中并经常检查润滑效果。
5、广东省明义机械贸易有限公司链条起动时,注意平稳,不得超负荷使用,不允许有偏载,以免链条因过载断裂和孔径拉长、销轴脱出而引发安全事故。
6、链条在使用过程中如遇到酸、喊性过大的污染物品,应及时对其进行清洗,并重新上油,以免造成对链传动机构产生腐蚀,影响使用 性能。

7、在更换链条时,应检查链轮齿形状况,当链轮齿磨成棘轮齿形或锅状形时,则更换新的链轮。严禁单纯地调换新链条,否则不但不能保证正常的链传动,甚至会造成链条不必要的早期损坏和失效。

欢迎各位拨打电话: 0317-2908675,或者到我们网站了解更多摩托车链轮!http://www.mingyishiye.com/

Ming Yi Machinery (Guangdong) Trading Co., Ltd. use, maintenance and maintenance of chain
1、The chain should be kept working under good environment condition during its drive operation and the protection device is indispensable to prevent obstacles such as dust, mud and sand etc、into chain、Cleaning the chain timely to avoid chain damage.
2、Adjust the tensioning device timely to keep the smooth operation of chain.
3、The chain in the course of normal wear causes the chain lengthened results chain the sag will gradually increase, the chain generated severe beating, increase chain wear, and even the jump teeth off the teeth, and should therefore be timelyadjust its tightness, and observe whether the front and rear sprocket and chain and related components along the same line, and found that the problem should be immediately corrected, remove troubles, be sure.
4、The chain should be kept clean, and its oiling and maintenance on a regular basis, it is best to use a 30, 40, oil, available oil (unconditional brush also can) the lubricant evenly distributed in the chain hinge gap and regular checks lubricating effect.
5、Ming Yi Machinery (Guangdong) Trading Co., Ltd. start of the chain, Note smooth, and shall not overload, do not allow partial load, in order to avoid the chain the fracture aperture elongated pin prolapse overload lead to accidents.
6、The chain in the course of such encounters acid, alkaline contaminated items should be cleaned and re-oiled, to avoid corrosion of the chain drive mechanism, affect performance.

7、Replace chain sprocket tooth prof丨le status should be checked, when the sprocket teeth grind ratchet toothed or pot-like shqpe, you must replace it with a new sprocket. Do not simply swap a new chain, otherwise it will not only fail to guarantee the normal chain drive, and even cause the chain unnecessary early damage and failure.

Welcome to call: 0317-2908675, or visit our website to learn more about motorcycle sprockets! http://www.mingyishiye.com/

1

鲜花
1

握手

雷人

路过

鸡蛋
该文章已有0人参与评论

请发表评论

全部评论

莆田百事通

扫一扫二维码关注我们Get最新资讯

相关分类
热点推荐
关注我们
莆田百事通与您同行

客服电话:400-000-0000

客服邮箱:xjubao@163.com

周一至周五 9:00-18:00

莆田百事通 版权所有

Powered by 莆田百事通 X1.0@ 2015-2020